3d Camera Tracking plane alignment problems

Back to 
3d Camera Tracking

3d Camera Tracking plane alignment problems

Created by Montgal_NYC
11 Months Ago
July 28, 2018 @ 11:58 pm

Hello Everyone:

I am performing a billboard replacement. And have performed a 3d Camera Tracker on the clip. After the tracker completed analyzing the footage, I needed to start finding a good Target Plane to take. Once I found one, I then right-clicked to chose Create Solid and Camera. I then noticed that I need to manipulate the corner-handles, independently to match the corners of the billboard I am trying to replace. Should I simply just keep searching for a different Target until the Solid Tracker aligns? Or, is there a way to adjust corner-handles independent of each other?

Your thoughts.

Thank you in advance for your assistance,
Alphonso, New York City

havardhv
11 Months Ago
July 30, 2018 @ 1:56 pm

This type of track/shot is pretty much made for Mocha. I would probably have used Mocha AE and export the tracking data with a corner pin. That way you (most likely) get a better track as well as the ability to adjust each individual corner.

Montgal_NYC
11 Months Ago
July 30, 2018 @ 17:47 am

Thank you for your thoughts. I will utilized Mocha Pro for this technique. It may be best because I could mask out the bus and van that passes the billboard. Again, thank you.

havardhv
11 Months Ago
July 31, 2018 @ 3:55 pm

No worries :-). Let me know how it goes

To join the conversation please register and log in - it's free
Back to 
3d Camera Tracking

STAY CONNECTED

Get in touch via social media

ABOUT TOBIAS

Tobias Avatar
I am passionate about providing high quality VFX & Film Making Edutainment online. Check out my training courses on Udemy
© 2019 Surfaced Studio